Repair GE-Emerson IC200ALG331 Versamax Analog Output Module

16-bit, 4 isolated 4-20mA current output channels.

Repair

$369.60
Availability
  • Usually ships in 3-5 business days

Remanufactured

$528.00
Availability
  • 3 in stock

For on-site repair and support, call us at 1-704-448-2212 or email sales@qualitrol.com.

Part Number
  • IC200ALG331REP
Manufactured
Product Specs

Features

  • Software configuration (no jumpers or switches)
  • 16-bit converter resolution
  • High accuracy factory calibration
  • Software-configurable features:
    • Per-channel selection of 4-20mA current or +/–10V voltage outputs
    • Selection of default/hold last state operation
    • Per-channel selection of default values
    • Per-channel selection of under- and over-range diagnostics levels
    • Per-channel selection of alarm levels
    • Per-channel scaling
    • Field re-calibration on command

The GE-Emerson IC200ALG331 Versamax Analog Output Module controls up to four analog devices. In current mode, a separate power supply may be required for isolated inputs. The module receives four words of analog output data from the system. For diagnostics, the module reports high/low Limit, over/under range, open wire, loss of field power supply, and non-volatile memory fault. 

The green FLD PWR LED indicates the presence of both logic power and field power for the analog field-side circuits. The absence of either backplane or field power turns off the FLD PWR LED.

The OK LED indicates module status. Note that this model is the only one that has its OK LED located before the FLD PWR LED in the A slot. 

Compatible with:

  • PLC CPU Firmware version 1.20 or later
  • Ethernet NIU EPI001 all versions
  • Genius NIU GBI001 Firmware version 1.10 or later*
  • Profibus NIU PBI001 Firmware version 1.10 or later*
  • DeviceNet NIU DBI001 Firmware version 2.10 or later

*For GBI001 and PBI001, NIU version 2.0 or above is required to perform software configuration.