Remanufactured GE-Emerson IC670ALG240 Field Control Analog Input Module

16 points grouped, accommodates 16 current loop inputs on a common power supply.

Remanufactured

$1,725.00
Availability
  • 9 in stock
  • Additional 23 ready to ship within 2-3 days

New Surplus

$3,200.00
Availability
  • 4 in stock

Repair

$1,380.00
Availability
  • Usually ships in 3-5 business days
Part Number
  • IC670ALG240RMN
Manufactured
Product Specs

Features

  • Supports 16 channels of input currents ranging from 0 to 25mA
  • Uses both word and bit data types
  • Can be field-recalibrated or reset to factory calibration
    • All calibration data is stored in FLASH memory
  • Two data acquisition rates base don 50Hz and 60Hz line frequencies
  • Individual channel configuration
  • 10mS or 20mS digital filtering may be used to eliminate noise
  • Selectable scaling of input data
  • Configurable high and low alarm values
  • Reports High/Low, Under/Overrange, and Open Wire alarms

The GE-Emerson IC670ALG230 Field Control Analog Input Module accepts inputs from two-wire or three-wire current transmitters and converts input levels to digital values. 

The module does not require a separate power supply to operate. However, power for the current loops must be provided externally. The most common application would have the loop supply local at the module, driving 2-wire loop-powered transmitters.

The module uses the following data types:

  • 16 analog inputs (16 words)
  • 88 bits of discrete input data for module and channel status (use of this data is optional)
  • 16 bits of discrete output data for fault-clearing commands to the module (also optional)

The module exchanges data with a Bus Interface Unit in the same manner as other types of I/O modules -- it provides all its input data and status bits when requested by the BIU, and receives fault-clearing commands from the BIU via its assigned output bits.

The module must be used with a Bus Interface Unit revision 2.0 or later.